RM-1 Zoning in Maple Ridge - Low Density Townhouse Residential
RM-1: Low Density Townhouse Residential is a residential zoning district in the City of Maple Ridge. This Zone provides for low Density Townhouse Residential where two or more Townhouse Dwelling Units are attached (s.617.1.1).
On a typical RM-1-zoned lot you can expect an FSR of about 0.6 and a maximum height of 9.5 m. Exact figures vary with lot size, frontage, and form of development, so look up your specific address to confirm.
Intent of the RM-1 district
This Zone provides for low Density Townhouse Residential where two or more Townhouse Dwelling Units are attached (s.617.1.1).
RM-1 at a glance
| Floor space ratio (FSR) | 0.6 |
|---|---|
| Max height | 9.5 m |
| Zone category | Residential |
Density tiers in RM-1
| Tier | Min lot area | Max units | Base FSR | Bonus FSR | Max height |
|---|---|---|---|---|---|
| Low Density Townhouse Residential | 1000 m² | - | 0.6 | - | 9.5 m |
| Low Density Townhouse Residential | 1000 m² | - | 0.6 | - | 9.5 m |
| Low Density Townhouse Residential | 1000 m² | - | 0.6 | - | 9.5 m |
| Low Density Townhouse Residential | 1000 m² | - | 0.6 | - | 9.5 m |
Permitted uses in RM-1
- Townhouse Residential
- Townhouse Residential subject to the Albion Area Density Bonus Amenity Contribution option (s.402.8)
- Single Detached Residential only on the eight site-specific Lots listed in s.617.2.1.c
RM-1 zoning FAQ
What is RM-1 zoning in Maple Ridge?
RM-1 (Low Density Townhouse Residential) is a residential zoning district in the City of Maple Ridge. This Zone provides for low Density Townhouse Residential where two or more Townhouse Dwelling Units are attached (s.617.1.1).
What can you build on RM-1-zoned land in Maple Ridge?
Permitted uses in RM-1 include Townhouse Residential, Townhouse Residential subject to the Albion Area Density Bonus Amenity Contribution option (s.402.8), Single Detached Residential only on the eight site-specific Lots listed in s.617.2.1.c. Permitted uses are allowed outright; conditional uses may require Development Permit Board approval.
What is the FSR for RM-1 in Maple Ridge?
Floor Space Ratio (FSR) in RM-1 is about 0.6. ZoneScout calculates the maximum buildable floor area for your specific lot.
How tall can a building be in RM-1?
RM-1 permits a maximum building height of 9.5 m. Height can be affected by view corridors, setbacks, and the specific form of development.
Other residential zones in Maple Ridge
- R-1 - Single Detached (Low Density) Urban Residential
- R-2 - Single Detached (Medium Density) Urban Residential
- R-3 - Single Detached (Intensive) Urban Residential
- R-4 - Single Detached (Infill) Urban Residential
- RE - Elderly Citizens Residential
- RG - Cluster Housing Residential
- RG-2 - Suburban Residential Strata
- RM-2 - Medium Density Apartment Residential
Look up a specific address in Maple Ridge
Source: official Maple Ridge zoning bylaw (PDF) · updated October 2026