An interactive map of White Rock lots, coloured by current bylaw-derived residential capacity. It shows exact unit counts for the City's small-scale housing zones and for RM lots regulated by a lot-area density rate.
Click a lot to see its zone, unit count, floor space ratio, the rule behind the number, and a link to the full bylaw-cited report.
Parcel area comes from ParcelMap BC. Unit counts use the same White Rock zone table and rules as the full report.
Every figure on this map is a starting point, not a permit. Actual capacity for a given site depends on lot dimensions, corner and lane conditions, easements, and form of development. Run the address for the cited, per-lot answer.
Most RS, RI and RE-2 lots permit three units at 280 m² or less, four units on larger lots below 4,050 m², and six where the City parcel flag confirms a prescribed bus stop within 400 m. The exact result depends on the zone and lot area.
RM lots use the zoning bylaw density rate and the parcel area. The map prints the resulting whole-unit count and colours it in the same 1-2, 3, 4-5, 6-7 or 8+ unit bands used across ZoneScout.
No. Each house-plex unit must have at least 96 m² of residential floor area. When the floor area fits fewer units than the entitlement, the lot panel states the smaller practical form count while keeping the bylaw entitlement as the headline.